Care Instruction Guide
Human Hair Wig:
Before washing, gently Detangle the wig using a wig brush or wide tooth comb. Start at the ends and work upwards to the base of the cap. For wigs with a tight curl, do not brush, use fingers and gently remove tangles. Do not brush when wig is wet.
While holding the wig, gently wet using cold water flowing in the same direction of the hair to avoid tangling, but Do not soak as this may cause the hair to tangle and mat together. Once wet, apply a small amount of a mild shampoo and distribute evenly throughout hair using your fingers.
Rinse with cold water to remove shampoo. Rinse so that the water is flowing in the same direction as the hair. Do not squeeze or twist.
Apply conditioner and distribute evenly all over the hair, leave for 15 minutes for a deep conditioning.
Rinse with cool water to remove conditioner. once the water is running clear, Gently pat and press with a towel to remove excess water.
Do not squeeze or twist.
Place on a collapsible wig stand to Air dry. To avoid stretching the cap Do Not place on a Styrofoam head to dry. Apply a leave in conditioning spray to wig when air drying.
You can curl or straighten your human hair wig as desired but try to avoid excessive heat as this will have a detrimental effect on the hair. To protect Use a thermal spray prior to styling.
-Wash your wig once a month for everyday use or after 25 wears, or as needed.
-Always use sulfate-free care products formulated for chemically processed hair to wash and style your human hair wigs to keep the hair soft and manageable.
-Never use hot water when washing, as it may loosen the wig construction
Gently brush wig or hairpiece to remove teasing or tangles.
Fill a basin or other bowl with enough cold water to cover wig or hairpiece. Add 1 capful of synthetic wig shampoo and then place wig in basin. Let soak for 30 minutes. Do not rub or twist! Rinse thoroughly with cold water.
Pat out excess water between two soft towels. Use a synthetic conditioning spray apply over the entire wig then allow to dry at room temperature naturally. Never put a wet wig on styrofoam, as it will stretch the cap. Do not brush or comb until completely dry.
*When wig is completely dry, it is ready to brush or comb. No setting is required because its preset body will bounce back to its original shape.
DO NOT USE HAIR DRY, BLOW DRYER OR CURLING IRON. AVOID EXCESS HEAT. SUDDEN BURSTS OF HEAT, SUCH AS OPEING AN OVER DOOR, WILL DAMAGE YOU SYNTHETIC WIG OR HAIRPIECE.
HOW TO PUT ON YOUR WIG
First secure your own hair by pinning or using a wig cap. Then hold your wig by its sides and slip it over your head. Adjust until the wig look like your own hairline at the front. The sides will be a close fit, and the entire head shape will look natural. The wig can also be adjusted by using the adjustment straps located in back of wig.
Your new synthetic wig can be easily styled by sing a wig brush. Height can be achieved by gently lifting with a brush. your synthetic wig can be styled closer to the head for a flatter look. If added fullness is required, tease gently or back comb, then smooth the surface hair over the teasing. Any synthetic styling products may be used if desired. Do not use any human hair products on synthetic.